The raft is an optional thick base layer which serves as the foundation layer between the build surface and the part. A single outline is sufficient to prime the nozzle, while 5 or more should be used to confirm accurate bed-to-nozzle spacing. Skirt Outlinesĭetermines the size of the skirt. When this is 0, the skirt is referred to as a brim. Skirt Offset from Partĭetermines the offset between the skirt and the part. Generally set to 1.įor parts with a very small cross section or contact surface area on the first layer, you may want to increase this number up to 5 to provide a solid foundation. Skirt Layersĭetermines the height of the skirt. For dual extruder prints, set this to “All Extruders”. Set this to the same value as the Primary Extruder in the Layers tab for single extruder prints. Specifies which extruders print the skirt. If the part does not need the extra build plate adhesion from a brim, a skirt is still useful for confirming that the models are properly placed and bed-to-nozzle spacing is accurate. When there is a gap between the extension and the part, it is referred to as a skirt and its purpose is usually to prime the nozzle prior to printing the model. When this extension is directly connected to the part, it is referred to as a brim, and its purpose is usually to provide additional surface area for the part to stick to the build surface. Both the skirt and brim refer to an extension of the first layer of your print which follows the contour of the model.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |